Ultrasonic Type Fuel Flow Meter / Flow Indicator / Water Flow
Switch
Introduction
The ultrasonic water meter is an innovative water measuring device
capable of detecting time differences resulting from changes in
speed as ultrasonic beams propagate downstream and countercurrent
in water. It analyzes and processes the water flow rate to further
calculate the water discharge.
The KACISE KUHM2000 series ultrasonic water meter incorporates
cutting-edge non-magnetic technology, offering high precision,
stable operation, easy maintenance, robust corrosion resistance,
long service life, an aesthetically pleasing design, safety, and
affordability. It finds broad applications in industrial process
measurement and control, serving as a reliable alternative to
mechanical flowmeters to enhance measurement accuracy and
reliability. The meter comes in three sensor types for measuring
pipe flow: clamp-on type, insertion type, and inline pipe type.
Additionally, it can measure heat if a temperature sensor is added.
An optional SD card feature allows for the storage of a large
quantity of data.
Insertion Type:
Only two installation holes required on the pipe for sensor
installation.
No-stop-flow installation achieved using the hole-making tool.
Sensors directly contact the fluid, ensuring stable and reliable
measurements.
Clamp On Type:
Sensors clamp onto the outside of pipes without contacting the
internal liquid.
All models can function as energy meters when connected to
temperature sensors.
KUF2000 Series Clamp On Ultrasonic Flowmeter allows easy
installation without cutting off the pipe or water, minimizing
pressure loss.
Supports long-term online measurements.
Wide range of liquid flows can be measured with the sensor clamped
on the pipe.
Inline Pipe Type:
For DN15-32mm pipes, π shape inline pipe sensor is used.
For DN40 and above, standard inline pipe sensor is used.
Inline sensors offer advantages such as low starting flow rate,
high measurement accuracy, and no pressure loss.
Parameters
Host part | Principle | Ultrasonic time gap |
| Accuracy | ±1% |
| Display | 2×20 character LCD with backlight |
Signal output | 1 way 4~ 20mA output, electric resistance 0~ 1K,accuracy0. 1% |
| 1 way OCT pulse output( Pulse width 6 ~ 1 0 0 0 ms,default is 2 0 0 ms) |
| 1 way Relay output |
Signal input | 3 way 4~ 20mA input, accuracy 0. 1%,acquisition signal such as temperature, press and liquid level |
| Connect the temperature transducer Pt100, can finish the
heat/energy measurement |
| Data interface | Insulate RS485 serial interface, upgrade the flow meter software by
computer, support the MODBUS, METER-BUS etc. |
| Cable | Twisted-pair cable, generally, the length under 50 meters; Select the RS485 communication. The transmission distance can over
1000m. |
Pipe Condition | Pipe material | Steel, Stainless steel, Cast iron, Copper, Cement pipe, PVC,
Aluminum, Glass steel product, liner is allowed. |
| Pipe Diameter | DN15~6000mm |
| Straight length pipe | Transducer installation should be satisfied: upstream10D,
downstream 5D, 30D from the pump. |
Medium | Type of Liquid | Water, sea water, waste water, oil, chemicals (alcohol, acids,
etc.), plant effluent and other liquids |
| Temperature | -30~160°C |
| Turbidity | 10000pm not so much bubbles |
| Flow speed | 0~±10m/s |
| Environment | Temperature | Host: -20~60°C; Sensor: -30~160°C |
| Humidity | Host: 85%RH; Flow sensor: IP68, less than 2m under water |
| Power supply | DC8~36V or AC85~265V or Battery |
| Consumption | 1.5W |
Optional Host
Sensor Selection
Optional Temp. sensor
Ordering Infomation
